Synchronous Dowel Pin Hidden Drawer Channel
Logo:Customized
Packing:4 Sets/carton
design customization
Please fill out the form below to request a quote or to request more information about us. Please be sure to upload customized requirement documents or pictures, and we will get back to you as soon as possible with a response. we're ready to start working on your new project, contact us now to get started.
Please fill out the form below to request a quote or to request more information about us. please be as detailed as possible in your message, and we will get back to you as soon as possible with a response. we're ready to start working on your new project, contact us now to get started.
SL4710 Synchronous Dowel Pin Hidden Drawer Channel
Full Extension Synchronized Soft Closing Undermount Drawer Slides
Product Description | |
name: | SL4710 Synchronous Dowel Pin Hidden Drawer Channel |
Slide Thickness | 1.8*1.5*1.0 mm |
Side Board Thickness: | normally16mm or 18mm if needed |
Length： | 250mm-600mm |
Up & Down，Left & Right | ±1.5mm，±1.5mm |
Packing: | 1set/poly bag; 10 Sets/carton |
Capacity: | 30kg |
Sample date: | 7--10days |
Payment terms: | 30% T/T in advance, balance before shipment |
Opening Force Adjusment： | +25% |
PRODUCT DETAILS
SL4710 Synchronous Dowel Pin Hidden Drawer Channel | |
Use a jigsaw to cut two notches. The notches’ long edge needs to flush with the bottom of drawer. | |
Between the front bracket and back notch of drawer, place the left slide. You need to mark the pin location onto the back of drawer slide. This is where a hole need is to be drilled. Do the same for the right-side slide too. | |
Then for the roller drawer slides, you need to use a quarter-inch drill bit and create holes. | |
It should be just shallow enough for holding the pins at marked position on back of the drawer. |
INSTALLATION DIAGRAM
TALLSEN is a company of a few industry best working people who came together for spreading their idea, experience, and share of their story while working, to the people who are keen on home improvement, DIY supports, and expertise friendly tools.
Question And Answer:
Use a jigsaw to cut two notches. The notches’ long edge needs to flush with the bottom of drawer. Between the front bracket and back notch of drawer, place the left slide. You need to mark the pin location onto the back of drawer slide. This is where a hole need is to be drilled. Do the same for the right-side slide too.
Then for the roller drawer slides, you need to use a quarter-inch drill bit and create holes. It should be just shallow enough for holding the pins at marked position on back of the drawer.
{{item.score}} Stars
{{item.pre}}%
{{item.nickname ? (item.nickname.slice(0, 2) + '*****') : item.source === 1 ? 'mall buyer' : '--'}}
{{item.comment_time}}
Review in the {{item.country}}
{{itemAttr.params_key}}: {{itemAttr.params_value}}
Get in touch with us
Just leave your email or phone number in the contact form so we can send you a free quote for our wide range of designs
We are continually striving only for achieving the customers' value
Solution
Address
TALLSEN Innovation and Technology Industrial, Jinwan SouthRoad, ZhaoqingCity, Guangdong Provice, P. R. China
no data
Change market and languageCopyright © 2024 TALLSEN HARDWARE - tallsen.com |Sitemap
